The mechanical fasteners will hold the two together. No problem here using thinset and osb. It will probably be OK. Cement board, commonly sold under trade names such as Durock, Hardiebacker, and WonderBoard, is now the standard underlayment used for ceramic, porcelain, or stone tile laid with thinset mortar adhesive. Position each piece of backer board in the thin-set, press in place, and attach using special backer board screws on the spacing recommended by the backer board manufacturer.
Cover the joints in the backer board with fiberglass tape embedded in thin-set adhesive and allow to set before tiling. It can be used inside or outside and all the extreme weather. LN is perfect for bonding building materials such as wafer board, plywood, lumber, etc.
Fasteners must be corrosion resistant, galvanized or stainless steel. Fasteners shall be installed between 1 in. Joint-flashing material must be durable, waterproof material that does not react with cement based products. Other products may also be suitable. The rough or embossed surface of the sheet should face up, as applicable. Fasten the sheet with cement board screws, using a drill-driver, making sure the screws are flush with the surface of the sheet or are slightly recessed.
Space the screws 8 inches apart across the entire sheet. Use only cement board screws and alkali-resistant cement board joint tape. Standard screws and drywall joint tape will corrode or deteriorate from contact with cement board. Continue installing sheets to cover the entire area. Mix fresh mortar only as it's needed to prevent it from drying before you can use it up.
Apply cement board joint tape to all of the joints between sheets, adhering the tape with its self-adhesive backing. Mix more thin-set mortar and, using a drywall knife, cover the taped joints with a thin layer, much as you would do when mudding drywall joints. Tool the mortar with the knife so the tape is covered and the joints are flat and smooth.
Allow the mortar to cure completely, following the manufacturer's recommended drying time. Installing cement board on countertops is very similar to the process used on floors, but countertops usually need an additional strip of cement board along the exposed edge of the countertop. This creates the built-up edge for securing bull-nose or other forms of edge tile. Cement board on walls also uses the same techniques, but in this case, there is no layer of mortar behind the cement board as it is screwed directly into the wall studs.
Consult the cement board manufacturer for recommendations on using a moisture barrier between the board and the wall studs. This may be thick plastic sheeting or another type of water-resistant membrane. Actively scan device characteristics for identification. Use precise geolocation data.
Select personalised content. Most vinyl tile floors are thin enough to support the extra. Hardi board lap siding is an easy to install backsplash. How to install hardie board on floor. With the plywood in place, install the backer board as you normally would. This is a distinct advantage over plywood and drywall. If your floor meets the requirements, the next step is to ensure that it is structurally sound and free of damage.
Mark your hardie backer board with a marker and ruler for easier cutting. Proper installation of hardie board follows a basic procedure that ensures a secure, stable surface to support the tile. The plywood adds stiffness and stability to the floor. Cement board is a type of underlayment that is now standard for most tile installations, but particularly for floor tile.
Snap a grid of chalk lines to mark the location of backerboard. Fill the joints with mortar. Fasten the backer board to the floor using proper nails or screws, as recommended by the manufacturer, every 8 around the perimeter and all supporting the studs.
No extra layers of underlayment are required. Installing cement board at the beginning of your remodeling project is crucial when you want waterproof tile floors that will last for many years without cracking or other signs of damage.
0コメント